1.
Ballpark figure on how much wood I would use for one season (my house is 1800 sq ft) 27 September 2005, 6:23:23
|
2. 1)do you sell/can you get liquid to air heat exchangers for use in existing forced air heating systems?
2) would it be possible to pick up at your warehouse vs. shipping? 08 September 2005, 17:05:35
|
3. Can I install your wood boiler flue with my boiler and use the same chimney ?
07 September 2005, 14:11:27
|
4. Can these boilers draw combustion air from the outside?
Do the boilers meet any U.S. safety standards, such as UL listing?
How long does it take to get one once an order has been placed?
Are the Dakon Dor models also gasification type boilers? 17 August 2005, 10:55:17
|
|
5. can you recommend any good sources of water storage tanks 03 October 2005, 12:11:10
|
|
6. do you intend to import any boilers with oil backup like tarm has in the near future. 24 August 2005, 9:00:16
|
|
7. I enjoyed yhe brief video of the eko combustion chamber while gasifying the wood. How about a video of the stack/chimney outlet while both in gasification mode and while the boiler gasification chamber is bypassed so we can see the difference gasification makes 02 September 2005, 10:09:16
|
|
8. In your information on the EKO series, you mention a safety thermostat that shuts the fan down on reaching 180° water temperature. Is it possible to get a 200° thermostat installed instead? With a properly installed and insulated storage tank, the energy stored would then increase by almost 10%. We are thinking of constructing a 500-1000 gallon storage tank to be installed in the floor of the basement, super-insulated as a heat storage system. Heating and then maintaining temperature in this tank would allow us to fire the boiler only once per day, which is better for people who leave home to work. 02 October 2005, 20:18:31
|
|
9. Is it possible (and advisable) to hook up one of your wood boilers in series with an existing oil fired boiler on a HWBB system? (Each would have their own proper flue. The oil boiler would only operate when the wood boiler was low or out. The oil burner would control all HWBB functions. An overheat valve could be provided to dump excess wood boiler heat into a dedicated radiant heating loop in the slab.) Problems with this setup? 20 December 2005, 21:37:27
|
|
10. sgsdgdsg 10 May 2007, 9:53:22
|
11. There are a few questions I have:
-what has been your experience with the Czech company- reliability, build quality, etc.?
-I assume you have not sold them in the US for long, so what other experience can you rely on?
-I have looked at the Tarm Solo Plus for years, but can't justify the price since I have had a old Tarm for 25 years and heat with 100% wood. However, I would like to increase efficiency and reduce wood cutting. What is your delivered cost (Maine) for a KP-Pyro 32 including domestic hot water heater?
- Tarm recommends a heat storage tank. What are your recommendations?
-What is the expected life of the ceramic nozzle and replacement cost?
-Why the 5" limit on stick diameter? Especially if wood is in the 12% dry range?
Thanks for your input. 15 August 2005, 22:57:30
|
|
12. We live in northern WI and I stopped burning wood about 10 years ago, we have a 2000 SF home and at the time burned about 10 to 11 cords per year using a standard forced air stove. How much more efficient would your furnace be? Due to remodeling issues we removed the chimmey and don't like the wood mess in the house, so could this unit be placed in a out building and lines piped to the home about 75' away? Which unit if any would you recommend for us? thanks Keith 27 December 2005, 23:10:27
|
|
13. What is the general cost for these wood boilers??? 09 August 2005, 17:05:34
|
|
14. What is the price and BTU rating of the Eko Line 60 and 80 boilers? What would shipping cost to Fairbanks, Alaska? Would one of these be adequate for a 4400 sq. ft. home that has 8", with walls well insulated, that could experience -60 degrees F? Would the Eko Line be better than your other models? 29 September 2005, 23:55:19
|
|
15. What is the warranty on the eko and pyro boilers and whats the diff. between them? 13 August 2005, 8:44:39
|
